Import áfa és vám

Az EU-n kívüli rendeléseknél a megjelenített ár nettó, magyar áfa nélkül.

Az import áfát (országtól függően VAT, GST vagy fogyasztási adó) és az esetleges vámot a célország hatósága vagy a futárszolgálat számolja fel, amikor a csomag megérkezik. Mértékük az országod szabályaitól és a rendelés értékétől függ.

Ezeket az összegeket mi nem szedjük be, és a kosárban sem szerepelnek. Pontos összegről a helyi vámhatóság vagy a futárszolgálat tud tájékoztatni.

Termékeim (0)
A kosarad jelenleg üres.

Rohloff Cap for cable box – external gear mech

8.24 EUR
10.96 EUR
Cap with thumbscrew for the external gear mech cable box.
SKU: 8217
Raktáron van
Nemzetközi kiszállítás
14 napos visszafizetés
Örökös támogatás
Három év garancia

The Rohloff Cap for cable box (Art. 8217) is the replacement cover plate for the SPEEDHUB 500/14 external gear mech cable box, with the knurled thumbscrew shown in the photo.

Rohloff cap for the external gear mech cable box with knurled thumbscrew, 8217
Rohloff cap for cable box, Art. 8217.

Why replace the cable box cap?

  • Closes the cable box. The cap covers the cable pulley and the wound shifter cables inside the box.
  • Tool-free thumbscrew. The knurled screw is turned by hand – the same type of screw that locks the cable box to the external transfer box.
  • Simple swap. The cover is held by two Torx screws M4x10 (TX20), tightened to 3 Nm with a little grease.
  • No need for a whole cable box. If only the cap is bent, cracked or lost, replace just this part.

Who is it for?

  • Riders with a damaged cable box cover. After a fall on the drive side the flat cap is often the part that suffers.
  • Anyone missing the thumbscrew. Without it the cable box cannot be secured to the external transfer box.
  • Workshops. Spare for external gear mech service.

Compatibility

Rohloff part number8217
FitsCable box 8212 of the SPEEDHUB 500/14 external gear mech
Fixing2 Torx screws M4x10 (TX20), 3 Nm
IncludesCover plate with knurled thumbscrew (as shown)

Frequently asked questions

Does it fit hubs with internal gear mech?

No. Only the external gear mech (all disc brake SPEEDHUBs) has a cable box.

Do I need to readjust the cables after changing the cap?

No. The cap does not change the cable setup; just check that the cable pulley turns freely from gear 1 to 14.

Are the Torx screws included?

The photo shows the cap with its thumbscrew. If you also need the cover screws, tell us when ordering.

About Rohloff

Rohloff AG from Fuldatal near Kassel, Germany, builds the SPEEDHUB 500/14: a 14-speed gear hub with evenly spaced gears, a 526% gear range and a sealed oil bath. As robust as the hub is, Rohloff sells small wear and replacement parts individually, so a SPEEDHUB is repaired, not replaced.

BoodaBike (Massive Bikes, Budapest) is an official Rohloff service centre, trained by Rohloff, and an official European distributor of Rohloff hubs and parts. We sell genuine Rohloff parts and we are happy to help you identify the right one for your hub version.